Tooling & Cutting Dies
Applied Tungestenites high lubricity and friction reduction will enhance reduction in galling, chip evacuation and pickup.
WS2 Technical Information
Composition:
A single layer of modified Tungsten Disulfide .5 microns thick
Molecular weight of 248.02
Density of 7.4 gms/cc
Hardness of 30 Rockwell C
Non-magnetic
Uniform silver-gray in color
Substrates:
All ferrous and non-ferrous metals and selective manmade solids and plastics.
However, the harder the substrate, the better the bond.
Adhesion:
High velocity impingement applied at ambient air temperature.
No cure time required
No binders or additional adhesives
Temperatures Range:
-460°F to 1200°F (-273°C to 650°C) in normal atmosphere
-360°F to 2400°F (-188°C to 1316°C) in hard vacuum
Load Capacity/Pressure:
Same as substrate to 100,000 psi
Coefficient of Friction:
Dynamic 0.035 Static 0.07
Coefficients lower then .05 are attainable but will vary with humidity
Chemical Stability:
Inert, non-toxic and non-corrosive
Accepts petrochemical oils and greases, synthetic oils, silicone lubricants and hydraulic fluids.
Does not prevent corrosion of substrate
Lox Compatibility:
Insensitive to detonation by or in the presence of oxygen